Guest Hamid Posted June 19, 2013 Hi, I need help for running a 3d Basin model. As recommended in the manual I have set the model in 2d and run and validated the results. But the available material in the manual for running the 3D is not self descriptive enough to convert the 2d to 3d. As noted in section 8.5.3, I added the vertical mesh type Sigma and Number of Sigma layers to the model and the model is run with the above added syntaxes. However I am not sure whether or not is using them to run the model in 3d. Is there any other syntax required for runnig in 3d using the default values? Is there any way that we can check the results at different layer using SMS interface? Regards, Hamid Quote Share this post Link to post Share on other sites